Remove the old steeringhead bearingcups. Mount the new cups in the steeringhead, the cup with the notch under, the flat cup on the top-side.
Drill a 5 millimeter hole in the in de lowerside of steeringhead, use the hole in the bearingcup as a drillguide. Tap a 6 millimeter thread en mount the set screw with a drop Locktite. Place the lockplate over the steeringhead stem. ATTENTION: There are two different sizes positions. Use the largest as possible, without the fork hits the gastanks. Mark the four hols on the lower triple tree and drill the holes 3,3 millimeter. Tap M4 thread and mount the four screws with a drop Locktite.